Example: ethtool hardware settings
This example configures ethtool hardware settings:
- change auto negotation to 10 or 100Mbps FD
- disable flow control
- add an ipv4 address
- set the link state to
up
ifstate
interfaces:
- name: eth0
addresses:
- 192.0.2.1/24
ethtool:
change:
autoneg: on
# 0x002 10baseT Full
# +0x008 100baseT Full
advertise: 0x00a
pause:
autoneg: on
tx: off
rx: off
link:
kind: physical
state: up
manually
ethtool --pause eth0 autoneg on rx off tx off
ethtool --change eth0 autoneg on adverstise 0x00a
ip address add 192.0.2.1/24 dev eth0
ip link set eth0 up